Home Assistant - Setting Min, Max, and Ramp Rate

Switches General Discussion
, , , , ,
#1

Hi Inovelli Community!

I just installed the first of 10 of the new dimmer switches, and so far I am really loving it! After doing some fiddling around with LED’s to get them all to be the same brightness at every level of dimness, I have determined that I need to adjust my min and max levels and would also like to adjust my ramp rate on and off. I am using Home Assistant and I just cannot figure out how to change these parameters. Is it even possible to do this in Home Assistant yet?

#2

I asked a kinda similar question here.

That should get you going in the right direction.

#3

Thanks, @cmminear, I must have glanced right past the switch parameters on the directions while installling. I’ll give it a try this weekend and see what I can come up with. These switches are really feature packed!