LZW-30 LED on when switch is off?

Switches General Discussion
,
#1

The older NZW switches have the ability to set the LED to be on when the switch is off. I don’t see this setting on the LZW-30 - am I missing it or has that been removed?

LZW:

54%20AM
54%20AM1228×884 33.7 KB

NZW:

03%20AM
03%20AM1214×1088 80.1 KB

#2

I think that you just flip-flop the intensity settings. By default, he LED is on at a very low level when the switch is off. So I think you just increase the OFF intensity value and decrease the ON intensity level.

That being said, there was an issue when adjusting the OFF value, discussed somewhere in this forum about six months ago. Not sure if that will factor in or not. I’ve left my OFF values at the default.

1 Like
#3

Thanks, I’ll give that a shot.