I have essentially the same question (Home Assistant, ZHA, multi-area detection, VZM32-SN).
As far as I can tell, I am able to configure the areas, but not sure how to detect if a given area is currently occupied.
Based on this link (Blue Series mmWave Presence Dimmer Switch • Advanced mmWave Configuration | Inovelli Help Center), it seems like I should be able to get this status information from “Server → Client Commands” parameter 0x00 and 0x01, but I’m not sure where to find those parameters.
I’m also thrown off by this message on that same site.
I’ve enabled attribute 107, but I’m not sure how to bind to cluster 0xFC32 EP1.
0xFC32 does not show up in the list of possible items to bind to, within the “Manage Zigbee device” Bindings screen.
If I could read the values from parameter 0x00 and 0x01, I think that would get me what I need.
Any help would be greatly appreciated.