LZW45 Animations don't work past splitters/corners

[stu1811]

There should be an end cap the goes in the end straight across the T. I think there was a reference to it in another post. Let me find it…

Edit:

Taken from:

RGBW LED Lightstrip (Project Cribs)

Animations will go down the straight side of the connector. When it reaches the end, it will continue on from the other side of the connector, like this: [image] I believe the current firmware supports up to 130 “pixels” (each pixel being an RGB LED). There are 8 pixels per foot, so this would mean a potential maximum of 16 feet with the current firmware. Since the T connector is not splitting the signal into 2 simultaneous strips, you would not be able to run 2 16-foot sections as this w…