Thank for the response!
So when SBM is enabled, the switch is now just a scene controller. Pressing up on the paddle is sending a button 1 pushed message to the hub.
Ahh, drat, I’m realizing that I misspoke about what it means to set parameter52 to a value of 1. Sorry for the confusion. I’ll try to rephrase:
In other words, I have parameter52 (confusingly labeled as “Smart Bulb Mode” by the Device Handler; alternatively labeled as “Switch Mode” in the community manual) set to “1”. I misspoke that this means “enabled”, though. Instead it means:
0 = Normal operation
1 = On/Off Mode - Switch will either be in the state of 0% power or 99% power, not allowing dimming. Useful for non-dimmable bulbs or other unique loads
2 = Smart Bulb - Switch always at 99% for use with loads like an Inovelli Bulb or Philips Hue Bulb. Use in conjunction with associations or scenes to achieve an awesome smart bulb experience
I think you’re referring to the “2” setting, whereas I’m trying to troubleshoot the “1” setting. The bulbs in my sockets are regular “dumb” bulbs.