Blue mmwave custom quirk

Product Support
, , ,
1

Two questions on the blue mmwave dimmer switch.

  1. I installed a custom quirk because I wasn’t getting any parameters for mmwave in the ZHA configuration. Now that I did it, I am showing two parameters for every setting. (picture below).

  2. When should I expect ZHA to show firmware update from the origional. I am not too technical and want to wait for update from home assistant.

image
image371×574 20 KB

2

The double entry thing is a known issue with the custom quirk. When an official update is available is kind of up to the ZHA maintainers. My understanding is that an update is in the queue with them, but it has not yet been approved and merged. At least that was the status last time I checked (which has been a little while).