Currently running firmware 1.02 and the driver “2024-10-22” with hubitat in LR mode. If i set an attempt to set association group 2 or 3 i get an error that 2 is above the max association group of 1.
Error:
Association group is invalid 1 <= 2 <= 1
Any suggestions?
Ahhhhhhhhhh. LR does not meaningfully support association groups. Thanks to @BertABCD1234 for educating me.
A Z-Wave Long Range node must only support the Lifeline Association group and it is only allowed to define one node ID, typically configured to the gateway destination.