Firmware v1.47 (Beta) | LZW31-SN | Dimmer - Red Series (Gen 2)

A few items:

A) After enabling the smart bulb parameter (52) the bulbs seem to hold their power at low dim levels. No resets, no flickering. Yea!

B) I’m not sure the documentation of “Disable Physical On/Off Delay” (parameter 51) is correct. The documentation says that when 51 is set to Yes than buttons 2-6 are disabled. Neither 6 nor 8 are disabled. And that’s good IMO as those buttons relate to the physical press and hold of the toggle buttons, which get mapped to raising and lowering of lights. It would be great to see even more minimization of response times for buttons 6 & 8 when set to Yes.

Relatedly, there is no documentation other than this community board ([HOW-TO] Hubitat: Setting Up "Scenes" in Rule Machine) with the button maps. And that documentation has the actions of buttons 6 & 8 swapped. IMO there should be an article at Knowledge Base Redirect – Inovelli for the buttons.

C)

I had to re-enable the local control parameter in Hubitat to get the expected functionality. Steps: 1) toggle “Disable Local Control” to No, save preferences 2) toggle “Disable Local Control” back to Yes, save preferences.

All in all the 1.47 update is really good!