[HOW-TO] Using the Z-Wave Association Tool in Hubitat

[zavex]

I had similar problems, see @jtronicus response to my question, it may be helpful.

LZW36 Z-wave association with Ilumin Bulbs not working

There are 2 components to setting local protection. The Local Protection setting just defines what is protected when local protection is enabled. If you havent already, make sure you enable local protection by holding the light dimmer up button and pressing the light on/off button 8x. Association Group 2 is tied to the light dim up/down buttons. Pressing the light dim up button 1x will send a basic set command to turn on associated devices. Pressing light dim down will likewise send basic…

In the end I ended up bypassing the module for the light and leaving the local protection off. Then I used association group 3, and has been working great.