@lavid You might want to adjust your power reporting. I have noticed that on some smart bulbs, there is a power fluctuation (usually when the bulbs are off) that can cause excess reports. Especially if there are a lot of devices involved. So, I would disable the ActivePowerReports from the exposes tab (set it to 0).
Then, on the reporting tab change “activePower” Min rep change. If you watch the logs, you can see the power bouncing back and forth. With my 6 hue bulbs it would bounce from 2 to 18 (.2W to 1.8W). I set my min rep change to 25 to cover the difference between 2 to 18 (could have done 20, but did 25 for good measure). I also set the min rep interval to 5 so that when I turn the switch from off to on it will only take a max of 5 seconds to show the power change in the GUI.