image not found img not found

LZW36 - Slight Flicker

I have 3 LZW36’s set up and I have noticed now on all 3 that the lights have flickered off and back on very quickly but just enough to notice randomly a few times since setting it up a week ago. Is this something that will be fixed with firmware? Is there an RF signal being made or is this a different problem?

Oh good, it’s not just me.
I get it when the light is about 60%, it will flicker.

I just haven’t bothered to do anything about it yet as it’s installed in a guest room that doesn’t get used much.

I’ve had the same issue (with my lights at 100%). The timing isn’t super consistent for me, but one afternoon I timed it and it was almost once an hour ±5min. Although sometimes it happens every half an hour or so. I didn’t see any logs in hubitat around that time from it (I was hoping maybe it was reporting and causing it to flicker)

Running the beta firmware on the switch (1.34). It happened with the original stock firmware, as well

I tried three different sets of bulbs and they all did it. After going through some replacements on my first set, I bought two different sets in case it was a compatibility issue (seemed unlikely, but figured it would be easier to test that way).

These are the three:
https://www.amazon.com/gp/product/B085L4FF8N
https://www.amazon.com/gp/product/B086198GW3
https://www.amazon.com/gp/product/B07FCM2CBB (ended up leaving these in)

I’m currently using halogen lights and have not upgraded to LEDs and my fans have an E11 base. Is this an issue with the canopy? This seems to happen to me about 5 times a day.

My lights are at 100% brightness.

I have the same issue! I also had an issue where the buttons stopped responding. I disabled the power monitor like was suggested elsewhere and that seems to be fixed, but the lights still blink randomly.

I actually came here to ask about this very issue, glad to see it isn’t just me because I installed 3 switches in one day, but also on 3 new fans that I installed at the same time I installed the switches. All 3 blink randomly, it is just a quick flash and then it won’t do it again for a while. I know I need to upgrade the firmware, but I just wan’t sure if I had issues with my new fans, new bulbs. or new switches.