LZW42 / Hubitat - switch state not refreshing

I’m running the latest Inovelli-issued drivers and Hubitat firmware. I have not updated the bulbs past 2.28 as the changelog doesn’t identify anything that should affect this.

I’m having an issue where I can turn the bulb on and off via scenes, but the state is not refreshing until I tap “refresh” on the device page. This appears to be an issue with on/off/level commands. Setting color temperature gets an immediate update.

These bulbs are new to me today – I’ve included them, put them where they needed to be, then run a z-wave repair.


Edit with update: when I use Hubitat’s drivers (not the ones published by Inovelli), the device behaves as expected.