No-neutral install with load and line in separate boxes

[Bry]

@Sam2314 See this thread with a similar issue. Yours is not an uncommon problem.

LZW31-SN Dimmer Red Series (Gen 2), GE Aux switch, No Neutral wire: Aux can turn off but not on

Adding a comment as I just installed my first Inovelli switch (lzw31-sn) along with a Homeseer Ha-100 auxillary switch in a non neutral setup. Same issue with aux not turning off and same temp solution of changing to neutral and setting dimming to 70%. Voltage at traveler is 49.8V with aux switch not pressed and 105V with up pressed and 98.5V with down pressed. At that time I had a mix of fluorescent and 8.8w FEIT led bulbs (2 bulbs in 2 fixtures) I replaced the LED bulbs with incandescents and…