I am in the same situation. My red switch does not turn off the load. I have tried the hardware reset recommended (hold config for 20 seconds) but instead of the LED turning red, I have it turn green after about 10 seconds, then yellow after another 10 seconds, the finally purple.
I have tried tapping config 8 times to toggle local control, that didnât make a difference.
Interestingly enough, before I excluded the switch I have tried toggling the âsmart light modeâ even though it only controls a couple of plain old LEDs, and that made them brighter.
The plot thickens⌠I excluded and re-added it, and now I can control it, mostly.
When I turn it off, it dims quite low. I can turn it on to 100% and it goes brighter, but even when dimmed all the way down or turned off, there is still some residual load.
This is a plain single pole switch, using neutral, driving two incandescent light bulbs of 40W each (they are in a special light fixture, and we havenât found LEDs that complement or match the style).
I pulled your posts into a new thread since your problem is with a red 2-1 and the previous thread was for a red (gen 2) relay switch. They have different button combinations and settings so those techniques from that post would not apply to this one.
Hopefully this will help get you some more visibility on the issue too.
Are you using a quick down paddle press to turn off the dimmer? Iâm asking because some incorrectly thought the dimmer would turn off by holding the down paddle. When you do that, it will only dim to the lowest level, but not turn off.
As a double check, look at the switchâs status in the hub to make sure it is really off.
Correct - single quick tap to turn off. In Home Assistant the state was in sync with my actions. Whether I turned it off from the switch or from Home Assistant, the behavior is the same.
I donât believe this is the correct method to factory reset it. I thought it was config+up paddle then release paddle then config button (or vice versa). Thatâs the way it is for Blues. The old Gen 2 reds were hold config for 20+ seconds.
Resources | Red Series Smart 2-1 Switch (On/Off & Dimmer) - Manual still does not show what the correct method is. Do you happen to have a link to most up to date documentation? (I donât want to confuse the switch any further by doing more button maneuvers without knowing what Iâm doing.)
Regardless I forgot you had zwave and I believe excluding resets the switch (donât think zigbee spec requires it). Iâm only running blues so I am a bit off.
Thank you for the link and quoted reference. I will try it for completeness, but given that I have excluded then included back the switch and it still stays on, I am assuming it is busted.
Itâs certainly possible itâs busted, but I would expect that to end up with the load not turning on, instead of the not turning off behavior youâre seeing here because the 2-1s donât use a relay for driving the load.
I have the same problem for more than a year now. Already spoke with Eric and Customer Support, tried everything: factory reset, installed a capacitor on the load side, firmware upgrade, etc⌠nothing worked.
The RED or BLUE on the âdimmer modeâ keeps âleakingâ some current to the load side when it was supposed to be off.
The only way to turn the load off is changing the switch mode from âdimmerâ to âswitch onlyâ.