Hi! I just updated my LZW30 to 1.19, and now I’m trying to figure out how to setup parameter 51. The problem is, I use alarm.com so I can’t do it from the panel. Is there any way to configure that from the config button or the Z-Wave PC Controller program? Thank you

So, unfortunately you can’t set 51 from the switch as room was limited so we couldn’t put the code locally as well. As for changing it via PC Controller, I’ll defer to @EricM_Inovelli as I’m not entirely sure how to change parameters on there. I’ve only ever used it to update firmware. What device…

Oops, yeah it’s connected to Qolsys IQ2. But I think I’ll switch everything to Home Assistant. The setting for param 51 is doable from there? Thx

Ok no worries - I’ll see if @anon14959390 can reach out to his contact at Alarm.com and see if there’s a way to do it as he has Qolsys IQ 2 as well. Yes, you can do it via Home Assistant for sure!

Inovelli Community

Setting parameters

Product Support

black-on-off, alarm-com, solved, qolsys-iq2-panel, switches, troubleshooting

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled