The wiring in my house for the three way setup seems simplified and not follow the two wires configuration. The current existing setup: Switch 1 's wiring coming from two major cable and black wire from 1 cable, and white and red come from another cable. the switch 2’s wiring only coming from 1 c…

As @Bry would say, we need some better pictures to figure out what is going on. We’ll need to be able to see all of the wires inside the box and where they are going (what bundles are they attached to, etc) for both boxes to be helpful here. You will need to pull the right side switch forward on th…

I’m trying my best to take clear photoes. Let me know whether this works. Thanks in advance. [IMG_6607] [IMG_6609]

Still not very clear. The third wire (black) that connected to the 3 way switch with the red and the white… where does it go? The 3rd wire (black) in the romex bundle with the red and white coming from the switch where does it go?

[image] doug44444444: 's wiring coming from two major cable and black wire from 1 cable, and white and red come from another cable. the switch 2’s wiring only coming from 1 cable. I’m kind of confident I see what is going on here. It appears that they used single pole switches to imitate 3-w…

My original plan was to use all smart switches so I have purchased a lot of them. In current situation, I want to understand my options. Smart + Smart > Smart + Aux > Smart + Dumb Thanks a lot for all of your commens

This is a little bit better view of another box, only single cable. I feel the builder is kind of lazy in such case. (this house build in 2001) [IMG_6610]

So you have two possibilities, now that I see the other box. The first is that the line and load is in the double gang box. The other is that the lights are in between the two boxes. If it’s the former, you will be able to use smart switches in both locations, as it will be easy to send a hot and …

If you can trace the wires that I asked for in my previous post then I think I can help you. However you will probably need some wire nuts, a wire stripper and at least one 14AWG jumper wire (say about the length of the white one supplied by Inovelli and ideally black). What hub are you using? (Ap…

To make this simpler, this what I am guessing you will see… At the dual-gang box end: The black wire from the original 3 way switch will go to one of the 2 conductor + ground Romex bundles. The white wire from the same bundle will go to the bundle of white wires with the red wire cap. The black w…

If you have a multimeter. Pull the black from the switch in the single gang box. If you lose the lights and that black wire has 120v on it and the rest on every lead has zero then your input is wherever that black wire is tying into in the 2 gang. To make it a smart to smart switch, you want to pig…

Inovelli Community

Three Way switch Help - white series

Product Support Wiring Discussion

3-way, north-america, advice-requested

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled