Hey y’all, is anyone having issues with the White Series On/Off becoming physically unresponsive after just a few presses? Can still control the on/off capability remotely but the LED stops working until I pull the air gap. Pulling the air gap returns physical control for a couple presses but then the cycle repeats. This occurs both in and out of instant-on mode and I’ve made no further configurations.
Firmware 1.0.0, HomeKit. Single-Pole wired.
Several others, including myself, have reported this problem in another thread. (See link below.) The problem has been reproduced by the engineers and they are currently working on a fix.
https://community.inovelli.com/t/white-series-on-off-bug-enhancement-vtm30-sn
Confirmed, this topic is already x-posted there. This topic is an artifact from before the project vernacular got co-opted into bug discussion and forked into the bug report topic. Glad they’ve reproduced and am following over there.
This topic was automatically closed 67 days after the last reply. New replies are no longer allowed.