Blue Fan Firmware and Hubitat

Product Support Hardware & Firmware Help
, ,
1

I have Hubitat C8 Pro, trying to update the firmware to 1.07. The AI on Inovelli says use the Update Firmware Button, but it says “Firmware update for Kids fan, Inovelli 122F-0401-04010100 is not available.”

I have tried several methods to get this updated but the Inovelli AI is telling me that these drivers have not been added yet. Can you please add these ?

Want to use some of the features like:

130. Fan Control Mode

Which mode to use when binding EP3 to a fan module (Firmware 2.17+)

Is the 2.17 on the fan canopy model or on the switch ?

I am being told, “For firmware, Inovelli has to give it to Hubitat, and then @mike.maxwell will make it available for updates.”

2

Just an update. Looks like my dimmer switch is 3.04 so I am good there. However I can not get the binding to work at all. Most instruction are out of date for hubitat or tell me to use the Zigbee Binding app which no longer exists.

This is what I have done.

I have a blue 2 in 1 dimmer: dimmer_inblue_kids_living_room

I have the canopy module with 1 parent and 2 childs:

fan_inovelli_kids_room_fan (parent)

fan_Inovelli VZM36 Canopy Fan (child)

light_Inovelli VZM36 Canopy Light (child)

  1. I created (from groups and scenes) two groups.
    1st group: Kids Fan Light Group, select dimmer for group is light_Inovelli VZM36 Canopy Light
    enabled Zigbee group messaging, group activation device = dimmer
  2. Second group: Kids Fan Motor Group, select dimmer for group is fan_Inovelli VZM36 Canopy Fan. enabled Zigbee group messaging, group activation device = dimmer
  3. Went to Devices, the selected my dimmer (dimmer_inblue_kids_living_room). When to Preferences at top tab:
    a. 52. Smart Bulb Mode: Enabled
    b. 125. Binding Off-to-On Sync Level = Enabled
    c. 130. Fan Control Mode = Cycle
    d. 131. Low Level for Fan Control mode = 33
    e. 132 Medium Level for Fan Control Mode = 66
    f. 133. High Level for Fan Control mode = 100
    g. 134. LED Color Fan Control Mode = 170
    h. Group Bind #1 (I enter my Kids Fan Light Group id under Device Network Id, which states Group_1898. I entered 1898
    i. Group Bind #2 (I enter my Kids Fan Motor Group id under Device Network Id, which states Group_1899. I entered 1899
    j. Auto Group Bind was left at default OFF

I then go to my switch, push buttons and nothing happens. What am I missing ?