Help with logic of associations and scenes

Switches General Discussion
, , ,
6

I am taking a step back in thinking that I am trying to configure too many moving parts at once. So, all I am trying to do now is to get the switch (using the LZW30-SN driver), to be a scene controller for the 3 Illumin RGB bulbs connected to it using @EricM_Inovelli article here: [HOW-TO] Hubitat: Setting Up "Scenes" in Rule Machine

Steps taken:

  1. Confirmed with 100% certainty that the bulbs work (on/ off) with local control.
  2. Created a RuleMachine rule
    44%20PM
    44%20PM1496×2228 319 KB
  3. Disabled local control to the switch (understood that this is needed so the bulbs have power at all times).
  4. Nothing happens with the button presses. Well, almost nothing. Holding down button 1-press caused the lights to dim (not as a group, but one at a time and now they won’t turn back on).

So this is where I am. I am about to do a repair on the network again to see if that helps. Once I can get this figured out then I can consider incorporating the motion detector.

Any help is greatly appreciated!
Charlie-