[HOW-TO] Using the Z-Wave Association Tool in Hubitat

[EricM_Inovelli]

@spickard

I am trying to associate an older Go Control WT00Z-1 accessory switch to a Red Series Switch (LZW30-SN).

The source device needs special code in order for it to work with the association tool:

[HOW-TO] Using the Z-Wave Association Tool in SmartThings

You have to add the following methods (below). You also need the command “processAssociations()” somewhere appropriate for the specific device. If it is a sleeping device it needs to have this in its WakeUp Notification method. If it is an “always awake” device, it can be put in its “updated()” or “refresh()” method. That method returns the commands as “un-formatted” z-wave commands so they need to be formatted at one point. For example: def cmds = processAssociations() return commands(cmds) p…