Looking for a full list of all parameters and numbers for the Red Dimmer series

Sorting Category
#1

Been looking around but cannot find it …

Thank you.

Is there a parameter to turn scene "on" for red series dimmer?
#2

https://support.inovelli.com/portal/api/kbArticles/407409000007752479/locale/en/attachments/1abnfa5822ce11f1e4dfe9a7306effa38a8cf/content?portalId=edbsn8bb12d5f5a97d693e61ce4ce8a23f8b0e323eac44a6c2794f893e912acf005df&inline=true

#3

This also needs to be updated. As of v1.47 it has two more params:

Add parameter 51, to enable instant on (ie: disable the 700ms delay). Note, if you disable the delay, it will also disable scene control except for Button 1 (ie: tap up 1x or tap down 1x) and button 7 (config button). All other buttons (2-6) will be disabled.

Parameter 51
Size: 1 Byte
Default: 1
Range: 0-1
0: No Delay
1: 700ms Delay

Added parameter 52. Use to put the switch into “smart bulb” mode. If it set to 1, the power will output maximum % when the dimmer is on. 0 = normal operation, 1 = smart bulb.

1 Like
New Params from 1.47 firmware not shown
#4

Thank you.

#5

Updating for anyone who googles Inovelli Parameters in the future and lands here–

The updated manual is at Resources | Red Series Dimmer Switch - Manual
At the left go to Getting to Know Your Switch, then Parameters and there’s a nice chart.

1 Like