Hey guys, I have a Blue Series switch connected to a dumb light and I have an automation that sets only the top LEDs to 100% when it’s on, then 5% when it’s off. This works but the switch always goes fully on (all LEDs) for 2 seconds before the bottom LEDs go to 5%. This is the case for every swit…

I’m not sure I understand the issue, but I think this will do what you want [image] Blue Series 2-1 Switch - Enhancements/Bugs Thread General Discussion I believe existing Parameter 17 is the one you want. Try setting P17 to 0 “do not display load level” and I think that…

Overriding Blue Series natural LED on/off state

Switches General Discussion

mamber July 6, 2023, 6:34pm 6

I’m not sure I understand the issue, but I think this will do what you want

1 Like