I think I posted this one in an older thread. Lots going on I see.
My LZW30-SN (purchased thru Amazon in Jan) has locked up and been unresponsive occasionally and an air gap fixes it most of the time(previous versions of firmware). My issue now is the LED is frozen(V1.17&V1.19). No matter what I do I can only get an LED upon initial setting, air gap and reset, after that the LED freezes and doesn’t respond. See post below for info:
LZW30 -SN No LED Control
Currently I am running-
ST V3, LZW31-SN(x2), LZW30SN(Trouble switch), LZW36-SN
Zooz ZST10 ZUSB and PC Controller V5.39(latest) for Firmware flashing/Network maintenance
EDIT: Figured out the LED issue, seems fine now since with latest firmware.