This will be a thread for listing out any bugs you may find and/or any enhancements you’d like to see for the Red Series mmWave Switch (VZW32-SN). This is not a thread for troubleshooting personal problems – please create a new thread so we can properly help. Please select at least three tags: P…

I noticed “dumb switch” mode isn’t an option in a 3 or 4 way install. The instruction page currently talks about the depth of the switch. Is this a hardware limitation? If not, can we get a workaround? There is immense value in these switches going into a multi-way install.

You can do multi-way, you just need to do it with aux switches. It is a hardware limitation as I believe the mmWave sensor stuff took up a lot of space on the board, so the dumb switch support had to go.

@UngluedChalice is correct. You’ll have to use Aux switches or smart switches as the other switches for 3/4/n way use. [image] Z-Wave 800 Series Motion Switch | Project Linus (Red Series) You are correct. The original PRD called for dumb switch support to be included (like the normal dimmers). U…

It appears that Hubitat isn’t processing motion updates from the switch correctly. The log is properly reporting Switch - Laundry Room (motion) Config Report: P116=16777216 (mmWave Person in Area: 16777216) Switch - Laundry Room (motion): event 8 (Motion detection) Switch - Laundry Room (motion…

Following up to say the only way I have been able to activate smart bulbs based on movement in Hubitat is to set parameter 52 (smart bulb mode) to Enabled, parameter 110 (light on presence behavior) to Auto On/Off, and to then create an automation that looks for when the switch turns “on” (just the …

Definitely red series (z-wave) mmwave, just got them yesterday, and am using the red series driver from here: Hubitat/Drivers/inovelli-mmwave-dimmer-red-series-vzw32-sn.src/inovelli-mmwave-dimmer-red-series-vzw32-sn.groovy at master · InovelliUSA/Hubitat · GitHub

Ok. The product page says they’re still in production :man_shrugging:

They started shipping about a week ago: Z-Wave 800 Series Motion Switch | Project Linus (Red Series) - #159 by Courtney_Inovelli

Just installed the first of my red mmWave switch replacing a Jasco motion sensing switch in a room roughly 400cm left, 400cm deep, 200cm right. What I have observed is the switch really struggles to cover the room. It particularly has issues on the left side, depth and right it does ok. But for some…

I would really appreciate a simple walk-test toggle. I know I can configure the switch to flip the lights or whatever when it detects motion, but I’d really just like an option “for the next 10 minutes, make the LED bar red whenever you detect motion” and make it really sensitive so I can wander aro…

Inovelli Community

Z-Wave Motion Switch • Project Linus • Bug & Enhancement Thread

Product Support Hardware & Firmware Help