Lights flickering even in on/off mode

[seajungle]

@rohan

It uses the same dimming circuitry in both on/off and dimming modes.

If that’s the case, what is that click sound when turning it off and on in on/off mode? Sounds to me exactly like how a relay would sound, and in dimmer mode that sound never happens even if it’s doing the full 0 to 100% change.

Looking into it more, I see in the CEO’s post here that he says “The sound you hear is the relay opening and closing (NOTE: You will not hear this click in a non-neutral setting as the relay cannot fully close due to the switch still needing power to operate its Zigbee antenna).”

So it appears that there actually is a relay (and I am using the switch with a neutral wire).

@Bry

What bulbs are you controlling that are having the flickering issue?

Halo 6" Recessed Lights, HLBSL6099FS231EMWR

@SandyB

Is this a simple, single switch circuit (not a multi way)?

Yes

@SandyB

If so, have you tried the “Switch type” configuration to “Single Pole Full Sine”

I have set it to “Single-Pole Full Sine Wave” since day 1

@SandyB

And you’ve turned off power reporting

Is it this?
“ActivePowerReports
Percent power level change that will result in a new power report being sent. 0 = Disabled”

I have that set to 0 already, as it was something I read to do when looking into the flickering that has always happened with this switch. My issue is just that the flickering somehow got much worse since last week without me changing anything or adding anything to my zigbee network.